Siemens SINAMICS PERFECT HARMONY GH180 - Options for Log Control Menu (6)

6.15 Options for Log Control Menu (6)
Note
Changing Drive Parameters
Only Siemens trained personnel are authorized to change drive parameters.
Familiarize yourself with the safety notes in Section Safety Notes for Parameter Changes and
preferentially contact Siemens customer service before changing the default con󹪝guration.
The Log Control Menu (6) consists of the following menu options:
• Event Log Menu (6180)
• Alarm/Fault Log Menu (6210)
• Historic Log Menu (6250)
These menus are explained in the tables that follow.
Table 6-84 Log Control Menu (6) Parameters
Parameter ID Unit Default Min Max Description
Upload all logs 6150 Function Upload all logs (event, fault, historic), parameter
dump, and active SOP hex 󹪝le to a USB connected
disk drive.*
Event Log 6180 Submenu Access menu for event log. See Table Event Log
Menu (6180).
Alarm/Fault Log 6210 Submenu Access menu for alarm/fault log. See Table Alarm/
Fault Log Menu (6210).
Historic Log 6250 Submenu Access menu for historic log. See Table Historic
Log Menu (6250).
Table 6-85 Event Log Menu (6180) Parameters
Parameter ID Unit Default Min Max Description
Upload event log 6190 Function Upload the event log to a USB connected disk
drive.*
Table 6-86 Alarm/Fault Log Menu (6210) Parameters
Parameter ID Unit Default Min Max Description
Alarm/Fault log display 6220 Function Display the fault log.
Alarm/Fault log upload 6230 Function Upload the fault log to a USB connected disk
drive.*
Alarm/Fault log clear 6240 Function Clear the fault log.
Parameter Assignment/Addressing
6.15 Options for Log Control Menu (6)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 155