Siemens SINAMICS PERFECT HARMONY GH180 - Numeric Keys; Start Key; Stop Key

Note
Modifying the factory supplied program
Do not modify without 󹪝rst consulting Siemens customer service.
9.1.5 Stop Key
The [STOP] key is a programmable key located on the lower left side of the keypad.
In standard applications the [STOP] key is programmed via the SOP to select stop mode when the
drive is under local control. Stop mode shuts down the drive in a controlled manner.
Note
Modifying the factory supplied program
Do not modify without 󹪝rst consulting Siemens customer service.
9.1.6 Start Key
The [START] key is a programmable key located to the right of the [AUTOMATIC] key on the left
side of the keypad. In standard applications the [START] key is programmed via the SOP to start
the drive when under local control. The velocity command under local control is controlled by
the up and down arrows of the SIMATIC keypad or touch screen.
Note
Modifying the factory supplied program
Do not modify without 󹪝rst consulting Siemens customer service.
9.1.7 Numeric Keys
The numeric keys are located on the right side of the keypad. On the SIMATIC Keypad Touch Panel
the numeric keys may be hidded by pressing the hide icon and shown by pressing the show icon.
These 10 keys, labeled 0 to 9, provide the following functions:
• Entry of security access codes
• Speed Menu function
• Numerical Menu Access mode
• Change the values of parameters
Software user interface
9.1 SIMATIC Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 345