Siemens SINAMICS PERFECT HARMONY GH180 - Page 170

Parameter ID Unit Default Min Max Description
Display Network
Monitor
9950 Function
Refer to the NXGPro+ Communications Manual.
Serial echo back test
Note: Modems are
not supported on
newer drives 󹪝tted
with NXGPro+ Con‐
trols or on older
drives updated with
NXGPro+ controls.
9180 Function
SOP Functions 9110 Submenu Access functions that utilize the local serial port.
See Table Serial Functions Menu (9110).
TCP/IP setup 9300 Submenu Access functions that set the parameters for TCP/IP.
See Table TCP/IP Setup Menu (9300).
* Refer to Section Network Fast Register Access for PLC Applications in Chapter Advanced
Operating Functions for additional information.
Table 6-99 Serial Port Setup Menu (9010) Parameters
Parameter ID Unit Default Min Max Description
Modem pass‐
word
Modems are not supported on newer drives 󹪝tted with NXGPro+ Controls or on older drives updated with
NXGPro+ controls.
Table 6-100 SOP and Serial Functions Menu (9110) Parameters
Parameter ID Unit Default Min Max Description
System pro‐
gram down‐
load
Note: Not
available in
NXGPro+
9120 Function Transfer the SOP to a USB connected disk drive.*
System pro‐
gram upload
9130 Function Transfer the SOP to a USB connected disk drive.*
Display sys
prog name
9140 Function Display the current SOP name.
Select system
program
9146 nowago.hex Display the list of SOP 󹪝les on the 󹪞ash disk to select the
active one.
Display drctry
version
9147 Function Display the current directory 󹪝le version.
Multiple con‐
󹪝g 󹪝les
9185 O󹪜 Enable multiple con󹪝guration 󹪝les.
Parameter da‐
ta upload
9150 Function Transfer the current con󹪝guration 󹪝le from a remote
system.*
Parameter Assignment/Addressing
6.18 Options for Communications Menu (9)
NXGPro+ Control Manual
168 Operating Manual, A5E50491925A