Siemens SINAMICS PERFECT HARMONY GH180 - Page 171

Parameter ID Unit Default Min Max Description
Parameter da‐
ta
Note: Not
available in
NXGPro+
9160 Function Transfer the current con󹪝guration 󹪝le to a remote sys‐
tem.*
Parameter
dump
9170 Function Obtain a print out of the current con󹪝guration data.*
Menu based
timer setup
9111 Submenu Access the menu-based SOP timers 1 to 16.
MenuTimer
1-8
9112 to
9119
Sec 0.0 0.0 86400.0 Menu timers 1 to 8 timeout.
MenuTimer
9-16
9121 to
9128
Sec 0.0 0.0 86400.0 Menu timers 9 to 16 timeout.
Use parameter upload functions to transmit data from the drive to a USB connected disk drive.*
Use parameter download functions to move data from a USB connected disk drive to the drive.*
NOTICE
* NXGPro+ uses a standard driver and does not allow the installation of drivers, therefore some
USB disk devices may not be compatible with NXGPro+.
• When attempting to upload information using a USB disk drive, check the keypad display for
a failure message such as, "An error has occurred" or "Error opening output 󹪝le".
• If the upload fails, change the brand or type of USB 󹪞ash disk and retry.
• Refer to "USB 󹪞ash disk requirements", "Known Issues with USB 󹪞ash disks", and "Keypad
error messages" for more information on USB.
Table 6-101 TCP/IP Setup Menu (9300) Parameters
Parameter ID Unit Default Min Max Description
IP address 9310 172.17.20.16 0.0.0.0 255.255.255.255 Enter the drive IP address in dotted decimal.
Subnet
mask
9320 255.255.0.0 0.0.0.0 255.255.255.255 Enter the drive subnet mask in dotted deci‐
mal (keypad only).
Gateway ad‐
dress
9330 172.17.1.1 0.0.0.0 255.255.255.255 Enter the drive gateway address in dotted
decimal (keypad only).
Parameter Assignment/Addressing
6.18 Options for Communications Menu (9)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 169