Siemens SINAMICS PERFECT HARMONY GH180 - Page 172

NOTICE
Changing the Network Con󹪝guration Requirememnts
Changing the network con󹪝guration (e.g. parameter 9310, 9320, or 9330) requires exiting the
keypad menu to return to the main screen. Then wait 30 seconds and reboot the DCR.
• For versions 8.0.0 through 8.0.2, wait approximately 30 seconds and reboot the DCR.
• For versions 8.1.0 and above, the changes should take e󹪜ect within a few seconds. There
is no need to reboot the DCR.
• For all versions of NXGPro+, DO NOT USE the 192.168.1.xxx network (range 192.168.1.1
through 192.168.1.255) for network con󹪝guration. It will not work and ToolSuite access
will be lost. Access to ToolSuite iS recoverable via the Keypad.
Parameter Assignment/Addressing
6.18 Options for Communications Menu (9)
NXGPro+ Control Manual
170 Operating Manual, A5E50491925A