Siemens SINAMICS PERFECT HARMONY GH180 - Page 358

5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
)L[HGGLVSOD\
ILHOG
8VHUGHILQHG
GLVSOD\ILHOGV
/LQH
ILHOG
QDPH
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
02'(
Figure 9-7 Dynamic Programmable Meter Display
[MODE] 󹪝eld
The [MODE] 󹪝eld is 󹪝xed.
The last four 󹪝elds on the display contain parameter values that can be de󹪝ned by the user.
All four variable displays can be selected from a pick list using the display parameters (8000).
The [MODE] 󹪝eld displays the current operational mode of the system.
This 󹪝eld can have any one of the displays summarized in Table Line 1 of mode 󹪝eld depending
on the current operational mode or the current state of the drive.
Rollback [RLBK] Mode
The following 󹪝gure depicts the display in rollback mode.
)L[HGGLVSOD\
ILHOG
/LQH
ILHOG
QDPH
8VHUGHILQHG
GLVSOD\ILHOGV
5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
5/%.
Figure 9-8 Dynamic Programmable Meter Display in Rollback Mode
The KYPD 󹪝eld displays the current operational mode of the system.
This 󹪝eld can have any one of the displays summarized in Table Line 2 of mode 󹪝eld depending
on the current operational mode or the current state of the drive.
Regeneration [RGEN] Mode
The following 󹪝gure depicts the display in regeneration mode.
Software user interface
9.1 SIMATIC Keypad
NXGPro+ Control Manual
356 Operating Manual, A5E50491925A