Siemens SINAMICS PERFECT HARMONY GH180 - Page 359

)L[HGGLVSOD\
ILHOG
/LQH
ILHOG
QDPH
8VHUGHILQHG
GLVSOD\ILHOGV
5LJKWFROXPQRIGLVSOD\
VKRZVG\QDPLFYDOXHV
/LQH
ILHOG
QDPH




.<3'
,727
9/76
530
'(0'
5*(1
Figure 9-9 Dynamic Programmable Meter Display in Regeneration Mode
Modifying Parameter Values
The following sections illustrate the steps to take if attempting to locate and change the
following parameters:
• Ratio Control
• Motor Frequency
Example for changing ratio control parameters:
The metering display shows the commanded speed reference in percent.




+$1'
,727
9/76
530
'(0'
02'(
Figure 9-10 Status display in metering mode
1. Press the following key combination: [SHIFT] + [2].
( A r r o w K e y s S e l e c t )
( 2)D r i v e
Figure 9-11 Status display after [SHIFT] + [2] key sequence
2. From this point, you can select from the nine standard menus.
Use the up [⇑] and down [⇓] arrow keys, to select the desired menu.
Software user interface
9.1 SIMATIC Keypad
NXGPro+ Control Manual
Operating Manual, A5E50491925A 357