Siemens SINAMICS PERFECT HARMONY GH180 - Page 147

Table 6-72 Pick list for Analog Output Variable Parameters
Motor Voltage Neg Sequence Q Out Neutral Volts Analog Input #8
Total Current Input Frequency Synch Motor Field Input KVAR
Average Power Input Power Avg Motor Torque Drive Losses
Motor Speed Input Pwr Factor Encoder Speed Excess React Current
Speed Demand Ah Harmonic Analog Input #1 Speed Droop Percent
Speed Reference Bh Harmonic Analog Input #2 Torq Current (Iqs) Ref
Raw Flux Demand Total Harmonics Analog Input #3 Torq Current (Iqs) Fb
Flux Reference Xfmr Therm Level Analog Input #4 Torq Current (IqsFilt) Filtered
Current (RMS) 1 Cycle Protect Analog Input #5
Zero Sequence Av Single Phase Cur Analog Input #6
Neg Sequence D Under Volt Limit Analog Input #7
Table 6-73 Analog Output #1 Menu (4661)
Parameter ID Unit De‐
fault
Min Max Description
Analog variable 4662 Set the input variable for analog output 1.
Output module type 4663 Set the output type for the module:
• unipolar
• bipolar
Full range 4664 % 0 0 300 Scale the output range of the selected variable.
Table 6-74 Speed Setpoint Menu (4240) Parameters*
Parameter ID Unit De‐
fault
Min Max Description
Speed setpoint 1 4250 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 2 4260 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 3 4270 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 4 4280 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 5 4290 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 6 4300 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 7 4310 rpm 0 -18000 18000 Programmable speed setpoint
1
Speed setpoint 8 4320 rpm 0 -18000 18000 Programmable speed setpoint
1
Jog speed 4330 rpm 0 -18000 18000 Set the drive jog speed.
Safety setpoint 4340 rpm 0 -18000 18000 Safety override preset speed.
* Inputs are 󹪝xed in the command generator setpoint sources. Refer to Section Command
Generator in Chapter Operating the Control.
1
Can be selected through an external contact and the SOP.
Parameter Assignment/Addressing
6.11 Options for Auto Menu (4)
NXGPro+ Control Manual
Operating Manual, A5E50491925A 145