Siemens SINAMICS PERFECT HARMONY GH180 - Page 424

Modifying Parameter Values
The following sections illustrate the steps to take if attempting to locate and change the
following parameters:
• Ratio Control
• Motor Frequency
Example for changing ratio control parameters:
The metering display shows the commanded speed reference in percent.




+$1'
,727
9/76
530
'(0'
02'(
Figure 9-79 Status display in metering mode
1. Press the following key combination: [SHIFT] + [2].
( A r r o w K e y s S e l e c t )
( 2)D r i v e
Figure 9-80 Status display after [SHIFT] + [2] key sequence
2. From this point, you can select from the nine standard menus.
Use the up [⇑] and down [⇓] arrow keys, to select the desired menu.
3. Press the down [⇓] arrow key twice. The following 󹪝gure shows the display prior to the
selection of the Speed Setup Menu (2060).
( s u b m e n u)
( s u b m e n u)
( s u b m e n u)( 2 2 1 0 )
To r q u e r e f e r e n c e
( 2 0 0 0 )
D r i v e p a r a m e t e r s
( 2 0 6 0 )
S p e e d s e t u p
Figure 9-81 Status display after [⇓] [⇓] key sequence
4. Press the [ENTER] or right [⇒] arrow key to enter the Speed Setup Menu (2060).
( A r r o w K e y s S e l e c t )
( 2 0 6 0 )S p e e d s e t u p
Figure 9-82 Status display after [⇒] key sequence
Software user interface
9.6 ML Keypad
NXGPro+ Control Manual
422 Operating Manual, A5E50491925A