The DCR Ethernet port, located on the end of the DCR, is for maintenance only. It is secured by
physical access only. The port is capable of 10/100 Mb speeds.
Note
Siemens strongly discourages connection of this port to any network.
Refer to the NXGpro Communication Manual (A5E50226719) for further information and
supported protocols.
Figure 5-7 Ethernet on NXGPro+ DCR Chassis (bottom view)
Hardware User Interface Description
5.3 User Accessible Interfaces
NXGPro+ Control Manual
84 Operating Manual, A5E50491925A
To Next Page
Loading...
