Further Description of Auto-tuning
Auto-tuning provides motor information that optimizes the output processing control. Auto-
tuning is performed in two stages, both stages are optional. Enter the motor information if
available, as described in Table Auto-tune Menu (1250). Refer to Section Drive Tuning in
Chapter Operating the Control for further information.
CAUTION
Stage 2 Auto-tuning
Use of Stage 2 auto-tuning increases the current loop gains.
Do not use this function without guidance from Siemens customer service.
Failure to do so can lead to highly unstable performance.
Parameter Assignment/Addressing
6.3 Options for Motor Menu (1) - rst half
NXGPro+ Control Manual
96 Operating Manual, A5E50491925A
To Next Page
Loading...
