12.2 Series machine start-up
Data Backup and Series Machine Start-Up
12-190
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
12.2 Series machine start-up
Functionality
The objective of the series machine start-up is:
S to bring another control system at a machine of the same type to the same condition as
after a commissioning
or
S to bring a new control system to the initial state in case of servicing (after hardware repla-
cement) with lowest possible expenditure.
Start-up archive (NC/PLC)
The start-up archive (NC/PLC) incorporates the following data:
S Machine data
S R parameters
S Setting data
S PLC user alarm texts
S Display machine data
S PLC user project
S Part programs
S Cycles
S Work offsets
S Tool offsets
S Leadscrew error compensation data
S Drive machine data of SINAMICS
Start-up archive (HMI)
The start-up archive (HMI) incorporates the following data:
S User cycles
S User directories
S Language file SP1
S Language file SP2
S Start screen
S Online help
S HMI screens
To Next Page
Loading...
Need help?
General
