Siemens SINUMERIK 802D sl Instruction Manual

Creating a Drive Project
10.1 Creating a drive project OFFLINE
10-131
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
As shown in Fig. 10-13 below, the Project Wizard has created the Machine Tool V1_2
project and SINAMICS_In802D drive unit with a Control_Unit on board in the project
navigator.
Fig. 10-13 The STARTER “Machine Tool V1_2” project navigator
10.1.2 Configuring a drive unit
The following components are required in the example to configure a drive unit:
S Active Line Module
S Motor module
S Synchronous motor (e.g. 1FK6) with encoder for the servo control variant
S Asynchronous motor (e.g. 1PH7) with encoder for the servo control variant
To compile the components for the drive unit, proceed as follows:
1. In the project navigator, open the SINAMICS_In 802D directory and double-click the
Configure drive unit element (see Fig. 10-13).
As you can see in Fig. 10-14, the STARTER opens a wizard for configuring the drive unit
components.
Note
The graphical representation corresponds to the SINAMICS CU 320, there is no special
illustration for the CU 320 integrated into the 802D sl.
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English