Siemens SINUMERIK 802D sl Instruction Manual

6-49
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
Installation
Overview
To install SINUMERIK 802D sl, first secure the individual components on the site of installa-
tion and then connect them with each other. When doing so, observe the Section “Configu-
ring the electrical design” (see Chapter 7, “Connecting”).
Open-type equipment
The modules of SINUMERIK 802D sl are open-type equipment. This means that you are
only allowed to install SINUMERIK 802D sl in housings, cubicles or electrical service rooms.
Access to these housings, cubicles or electrical service rooms must only be possible using a
key or a tool and must be restricted to instructed or authorized personnel.
General procedure when installing SINUMERIK 802D sl
!
Warning
Before installing or removing the components of the SINUMERIK 802D sl control system,
make sure that the system is disconnected from the mains.
Note
When installing the control components, observe the dimensions given in Chapter 5. These
drilling patterns constitute the basis for preparing the mounting holes.
6
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English