7-51
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
Connecting
General rules
The present chapter describes various general rules for electrical design. You must observe
these rules to ensure trouble-free operation.
Safety rules
To ensure safe operation of your plant, realize the following measures and adapt them to
your particular conditions:
S An EMERGENCY STOP strategy in accordance with generally accepted rules of current
engineering practice
(e.g., European Standards EN 60204, EN 418, and the like).
S additional measures for the limiting of limit positions of axes
(e.g. hardware limit switches).
S devices and measures for protection of motors and power electronics according to the
design guidelines for SIMODRIVE or SINAMICS.
To identify hazard sources for the entire plant, we additionally recommend a risk analysis in
accordance with the general safety requirements/Annex 1 of the EC Machinery Directive
89/392/EEC.
In this context, observe also Chapter D, “Guideline for handling electrostatically sensitive
devices (ESD)” in this Manual.
Further references
For further information on EMC guidelines, we recommend the publication: EMC Installation
Guideline, Planning Guide (HW)
References: /EMV/, Description
Standards and regulations
When connecting SINUMERIK 802D sl, please observe the relevant VDE guidelines, in
particular VDE 0100 or VDE 0113 for disconnecting devices, short-circuit and overload
protection.
7
Siemens Automation Parts
To Next Page
Loading...
Need help?
General
