Siemens SINUMERIK 802D sl Instruction Manual

SINUMERIK 802D sl License Agreement
D.2 General Terms and Conditions for the Use of Software for Sinumerik and Drive Technology
D-245
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
6. If the Licensee is to receive only the data carrier, and not a license according to the provi-
sions in the Order Data or resulting from the CoL, the Licensee shall only be entitled to
use the Software if he acquires a license as mentioned in Point D.2.2 below. The Licen-
see shall only be entitled to pass on the Software to third parties if he has acquired the
license.
D.2.2 License type
Depending on the license type, the Software Licensee is granted the following rights:
1. Single License (One-Off License, Copy License)
The term “One-Off License” or “Copy License” used in the Software Product Form cor-
responds to the Single License. The following regulation shall apply to the One-Off Li-
cense/Copy License to its full extent:
The Licensee is granted the non-exclusive right unlimited in time and assignable in accor-
dance with Point D.2.5, Clause 3 below to install the Software on one (1) device and to
use the installed Software as specified in the Order Data or the CoL (see “Type of use”).
2. Floating License
The Licensee is granted the non-exclusive right unlimited in time and assignable in accor-
dance with Point D.2.5, Clause 3, to install the Software on any number of devices of the
Licensee. The number of persons who are permitted to use the software simultaneously
(“users”) results from the order data or the CoL (see
3. Rental License
The Licensee is granted the non-exclusive right limited in time as specified in the Order
Data or the CoL (see “Type of Use”) to Point D.2.5, Clause 3, to install and use the Soft-
ware on one (1) device. If the time of use is specified in hours, the time used to calculate
the limitation in time shall commence at the time when the Software was started first and
end at the time when the use of the Software is finally completed. If the time of use is
specified in days, weeks or months, the specified period shall commence from the time
when the software was started first, irrespective of whether or not the software is in fact
used.
4. Trial License
The Licensee is granted the non-exclusive, nontransferable right to install the Software
on one (1) device and to use the installed Software for validation purposes in the manner
as specified in the Order Data or in the CoL (see The time of use shall be limited to
14 days, commencing at the time when the Software was started first, unless another
time of use is specified in the Order Data or in the CoL.
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English