Siemens SINUMERIK 802D sl - Starting up the PLC

9.7 Starting Up the PLC
Commissioning
9-92
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
Note
The newly set PB station address is only active after POWER ON.
9.7 Starting Up the PLC
After starting up the Profibus, the prepared PLC user program is ready to run and can be
used for further start-up. To load the PLC user program, use the Programming Tool.
For a description, please refer to Section 11.5.