Siemens SINUMERIK 802D sl Instruction Manual

Creating a Drive Project
10.2 Operating the control panel in STARTER (with the motor rotating)
10-143
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
10.2.2 Operating the control panel
After you have established the connection to the target system and uploaded the project, a
green connector symbol is displayed in the Project Navigator in front of the drive unit and the
other components configured. This indicates that the project data in STARTER and the tar-
get system is consistent (see Fig. 10-32).
The drive unit is now ready to operate.
The following steps are required to operate the control panel in the STARTER commissio-
ning tool such so that the motor rotates:
Double-click Control panel in the
project navigator.
Green plug icon.
Fig. 10-32 Control panel
1. Double-click Control panel in the project navigator under Drive_1 > Commissioning
(see Fig. 10-32).
The control panel is displayed in STARTER (see Fig. 10-33). You can use the control
panel to control the drive directly from the PC/PG.
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English