Siemens SINUMERIK 802D sl Instruction Manual

SINUMERIK 802D sl License Agreement
D.2 General Terms and Conditions for the Use of Software for Sinumerik and Drive Technology
D-247
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
D.2.5 Further rights and duties of the Licensee
1. Unless a note to the contrary with specification of a certain number of copies is made on
the data carrier or in the readme file of the Software, the Licensee is permitted to make a
reasonable number of copies of each copy of the Software which he is entitled to use in
accordance with these Terms and Conditions exclusively for data backup purposes.
Furthermore, the Licensee is only permitted to duplicate the Software if and insofar as we
have granted rights of duplication in writing.
2. The Licensee is not permitted to modify, reverse engineer or recompile the Software, nor
is he permitted to segregate individual parts of the software, except where this is ex-
pressly permitted by the provisions of the laws on copyright. The Licensee is furthermore
not permitted to remove alphanumerical IDs, trademarks or copyright notes from the soft-
ware or data carrier and undertakes to duplicate such markings and notes unchanged
insofar as he is entitled to duplicate the Software. This provision applies analogously also
to the documentation provided in accordance with Section D.1.
3. The Licensee is entitled to transfer his rights of use in the Software to a third party, provi-
ded a written agreement is reached with this third party to the effect of all provisions of
this Section D.5 and provided he retains no copies of the Software.
If the Licensee has received a license key for the Software, this key must be passed on
to the third party together with the Software. Furthermore, the CoL is to be handed over
to the third party, together with these Terms and Conditions.
If requested by us, the Licensee is to be prepared to present the CoL received for the
Software at any time.
4. If the Software is a PowerPack or an Upgrade, the Licensee is to keep the Certificate of
License or the Software Product Form of the Original License and, if requested by us, is
to be prepared to present it together with the CoL received for the Software at any time. If
the Licensee transfers his rights of use in the PowerPack Software or the Upgrade Soft-
ware in accordance with Point D.2.5, Clause 3, the Certificate of License or the Software
Product Form of the Original License is also to be handed over to the third party.
5. If the Licensee receives a data carrier which contains further enabled software products
besides the Software, he is granted a right limited in time and without fees to use these
enabled software products exclusively for validation purposes. The time of use shall be
limited to 14 days, commencing at the time when the Software was started first, unless
another time of use is specified in the readme file of the software product concerned.
The provisions of these Terms and Conditions apply analogously to these software pro-
ducts provided exclusively for validation purposes. The Licensee is not entitled to transfer
these software products to a third party separately, i.e. without the Software.
Otherwise, the provisions of the purchase contract shall apply, unless contrary
provisions are specified expressly hereinafter for the Free Software.
Siemens Automation Parts

Siemens SINUMERIK 802D sl Specifications

General

Brand	Siemens
Model	SINUMERIK 802D sl
Category	Controller
Language	English