12.2 Series machine start-up
Data Backup and Series Machine Start-Up
12-192
SINUMERIK 802D sl Instruction Manual (BA), 05/2005 Edition
6FC5 397-0CP10-1BA0
Sequence with CF card
1. Creating a series machine start-up file on the CF card:
– Make sure that the CF card is inserted in the slot on the device front panel.
– The control system requires the password for protection level 2.
– In the System > Start-up files > 802D data menu, select the Start-up archive (NC/
PLC) line and use the Copy command to paste the contents to the clipboard. Select
the Customer CF card softkey to display the contents of the inserted card. If you se-
lect the Paste softkey and subsequently enter the name for the archive file, the series
machine start-up is produced on the card.
2. Reading in the series start-up file from the CF card into the SINUMERIK 802D
– Make sure that the CF card is inserted.
– The control system requires the password for protection level 2.
– In the System > Start-up files > Customer CF card menu, select the line containing
the appropriate archive and use the Copy command to paste the data to the clipbo-
ard. Select the 802D data softkey and select the “Startup data (NC/PLC)” line. Selec-
ting the Paste softkey will transmit the series start-up to the control system.
– Once reading-in has started, confirm the start of the series machine start-up in the
control system.
– A warm start of the NC/PLC is performed several times during the series machine
start-up. At the end of the series machine start-up, the whole control system will re-
boot (warm start). After an error-free series machine start-up, the control system will
be in a fully configured operating condition.
Start-up archive (HMI)
This data backup is created analogously to the start-up archive (NC/PLC). For creation and
reading in, select System > 802D data > Start-up files > Start-up archive (HMI).
To Next Page
Loading...
Need help?
General
