Siemens AG
Automation and Drives
Postfach 4848
D–90437 NÜRNBERG
GERMANY
Copyright (E) Siemens AG 2005.
6FC5397–0CP10–1BA0
Siemens AG 2005
Subject to change without prior notice.
Safety Notes
This Manual contains information which you should carefully observe to ensure your own personal safety
and the prevention of material damage. The notices are highlighted by a warning triangle and, depending on
the degree of hazard, represented as shown below:
!
Danger
indicates that death or severe personal injury will result if proper precautions are not taken.
!
Warning
indicates that death or severe personal injury may result if proper precautions are not taken.
!
Caution
with a warning triangle indicates that minor personal injury can result if proper precautions are not taken.
Caution
without a safety alert symbol, indicates that property damage can result if proper precautions are not taken.
Attention
indicates that an undesirable event or state may arise if the relevant note is not observed.
If several hazards of different degrees occur, the hazard with the highest degree must always be given
preference. If a warning note with a warning triangle warns of personal injury, the same warning note can
also contain a warning of material damage.
Qualified personnel
Start-up and operation of the device/equipment/system in question must only be performed using this
documentation. Commissioning and operation of a device/system may only be performed by qualified
personnel. Qualified personnel as referred to in the safety guidelines in this documentation are those who
are authorized to start up, ground and label units, systems and circuits in accordance with the relevant safety
standards.
Use as intended
Please note the following:
!
Warning
The equipment may only be used for single purpose applications explicitly described in the catalog and in
the technical description and it may only be used along with third-party devices and components
recommended by Siemens. It is assumed that this product be transported, stored and installed as intended
and maintained and operated with care to ensure that the product functions correctly and properly.
Trademarks
All designations with the trademark symbol are registered trademarks of Siemens AG. Other designations
in this documentation may be trademarks whose use by third parties for their own purposes may infringe the
rights of the owner.
Disclaimer of Liability
We have checked that the contents of this document correspond to the hardware and software described.
Nonetheless, differences might exist and therefore we cannot guarantee that they are completely identical.
The information given in this publication is reviewed at regular intervals and any corrections that might be
necessary are made in the subsequent editions.
To Next Page
Loading...
Need help?
General
