System
8.5 SYSTEM - "PLC" softkeys
Surface grinding
146 Programming and Operating Manual, 11/2012, 6FC5398-5CP10-3BA0
(GLW3/&
DODUPW[W
Structure of the reference list (file PLCPROG.LST)
It is divided into 3 areas:
Number range Protection level
1 to 100 User area User
101 to 200 Machine manufacturer Machine manufacturer
201 to 255 Siemens Siemens
The notation is carried out for each program by lines. Two columns are intended per line,
which must be separated from each other by TAB, space or the "|" character. In the first
column, the PLC reference number must be specified, and in the second column, the file
name.
Example:
1 | shaft.mpf
2 | taper.mpf
This function can be used to insert or modify PLC user alarm texts. Select the desired alarm
number using the cursor. At the same time, the text currently valid is displayed in the input
line.
Figure 8-42 Editing the PLC alarm text
Enter the new text in the input line. Press the "Input" key to complete your input and select
"Save" to save it.
For the notation of the texts, please refer to the operating instructions.
To Next Page
Loading...
Need help?
General
