Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
191
TOOLBASE_COL3=20
TOOLBASE_COL4=20
[DEFAULT SETTINGS]
; Create default tool settings:
; see paramtm.ini or paramtm.txt in path mmc2
; Magazine list: Load, data input directly in the list:
; 0=Due to the missing input, the default settings must be
; confirmed with the "Tool data" screen if they
; are required.
; 1=The default settings become effective without confirmation
; (with the exception of tool identifier no.)
; 2=The default settings become effective without confirmation
; (including the tool identifier no.)
DEFAULT_WITHOUT_CONFIRM=0
; Half locations: From 1 to 7
TOOLSIZE_LEFT=1
; Half locations: From 1 to 7
TOOLSIZE_RIGHT=1
; Half locations: From 1 to 7
TOOLSIZE_UPPER=1
; Half locations: From 1 to 7
TOOLSIZE_DOWN=1
; Tool type, from 100 to 1000
TOOLTYPE=120
; Duplo number: From 1 to 32000
TOOLDUPLO=1
; Ident. no.: Max. length 27
TOOLIDENT=NEW
; Additive values, (default: 0):
; 1=Active tool
: 2=Permitted
; 4=Blocked
; 8=Measured
; 16=Warning limit reached
; 32=Being changed
; 64=Fixed location coding
; 128=Already in use
; 256=Tool in buffer
; 512=Blocked, not taken into account (because of PLC)
; 1024=Out (unload)
; 2048=In (loaded)
; 4096=Standard tool (constantly in the NCK)
; 8192=
; 16384=
TOOLSTATE=0
; Index of a defined location type
To Next Page
Loading...
