Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
192 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
TOOLPLACESPEC=1
; 0=No monitoring (default)
; 1=Time monitoring
; 2=Workpiece count monitoring
TOOLMONITOR_MODE=0
; Tool search, number of replacement tool ($TC_TP10)
; 0 ... 32000
TOOLSEARCH_MODE=0
; Default setting of grinding-specific tool data at creation:
; If the machine is operating with inch/mm
; ($MN_CONVERT_SCALING_SYSTEM=1) conversion,
; the length unit must be specified.
; The following default values (TOOLGRIND..., if affected
; by the length unit) are specified on the basis
; of this length unit:
; 0 = mm (default)
; 1 = inch
TOOLGRIND_Default_Length_Unit=0
;Spindle number (as $TC_TPG1)
TOOLGRINDspinNoDress=1
;Chain rule (as $TC_TPG2)
TOOLGRINDconnectPar=1050629
;1050629 binary: 0000 0000 0001 0000 0000 1000 0000 0101
;Bit0=1 = Type
;Bit2=1 = Geo-L1
;Bit11=1 = Wear-L1
;Bit20 =1 = Base-L1
;Minimum wheel radius (as $TC_TPG3)
TOOLGRINDminToolRadius=0
;Minimum wheel width (as $TC_TPG4)
TOOLGRINDminToolWide=0
;Current width of grinding wheel (as $TC_TPG5)
TOOLGRINDactToolWide=0
;Maximum grinding wheel speed (as $TC_TPG6)
TOOLGRINDmaxRotSpeed=0
;Maximum grinding wheel peripheral speed (as $TC_TPG7)
TOOLGRINDmaxTipSpeed=0
;Inclination angle of inclined wheel (as $TC_TPG8)
TOOLGRINDinclAngle=0
;Compensation parameter for grinding wheel peripheral speed (as
$TC_TPG9)
TOOLGRINDparamNrCCV=3
[TMMODES]
; 0=Do not delete tool automatically
; when it is unloaded (magazine list only).
; 1=Delete tool automatically when it is unloaded
To Next Page
Loading...
