Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
206 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; the sequence in paramtm.ini.
; For the values of EdgeParamName... we used the character string
; "TC_DP..." to indicate how the texts relate to the
; associated NCK variables. However, other
; character strings can be used here because this text
; reference only defines a parameter heading and does not
; specify which data is read from the NCK.
; The value of EdgeParamName... is copied directly into the screen
; if [General] ReadLanguageIni=0 and in the tool
; detail screens the untransformed display is active.
; If [General] ReadLanguageIni=1 and in the tool
; detail screens the untransformed display is active, the
; value of EdgeParamName... is used as the access code to
; read the text from the locale-dependent INI file
; (language\patm_xx.ini, section [ToolEdgeParams], access code
; "TC_DP3" in this example).
; If in the tool detail screens the transformed display
; is active, the value of EdgeParamName... as access code
; is used for the [ToolEdgeParamsTrafoTextReplace] section in
paramtm.ini
; used. ; The value found there is then used as text or
; access code (depending on [General] ReadLanguageIni)
; in order to determine the output text for the tool detail screens.
; If an entry is not found in the INI files, the
; text is taken from the resource file language\pa_xx.dll.
; Lines UserDataParamName: Locale-specific mechanism
; Lines UserDataParamSize: Locale-specific mechanism
; Lines UserDataParamSizex: Locale-specific mechanism
; Lines EdgeParamName...: untransformed or
; transformed mechanism and locale-dependent mechanism.
[ToolEdgeParams]
; Length 1
EdgeParamNameLLen1 = TC_DP3
; Length 2
EdgeParamNameLLen2 = TC_DP4
; Length 3
EdgeParamNameLLen3 = TC_DP5
; Radius l1
EdgeParamNameRLen1 = TC_DP8
; Radius l2
EdgeParamNameRLen2 = TC_DP9
; Radius r1
EdgeParamNameRRad1 = TC_DP6
; Radius r2
EdgeParamNameRRad2 = TC_DP7
; Angle1
To Next Page
Loading...
Need help?
General
