Siemens SINUMERIK - Page 213

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
207
EdgeParamNameAng1 = TC_DP10
; Angle2
EdgeParamNameAng2 = TC_DP11
UserDataParamName1 = TC_DPC1
UserDataParamName2 = TC_DPC2
UserDataParamName3 = TC_DPC3
UserDataParamName4 = TC_DPC4
UserDataParamName5 = TC_DPC5
UserDataParamName6 = TC_DPC6
UserDataParamName7 = TC_DPC7
UserDataParamName8 = TC_DPC8
UserDataParamName9 = TC_DPC9
UserDataParamName10 = TC_DPC10
UserDataParamIO1 = <EndOfList>
; UserDataParamIO1 = Type:=Float, Res:=2
; UserDataParamIO2 = Type:=Int
UserDataParamSize = TC_DPC_UNIT
UserDataParamSize1 = <EndOfList>
; UserDataParamSize1=TC_DPC1_UNIT
; ...
; UserDataParamSize10=TC_DPC10_UNIT
ApplDataParamName1 = TC_DPCS1
ApplDataParamName2 = TC_DPCS2
ApplDataParamName3 = TC_DPCS3
ApplDataParamName4 = TC_DPCS4
ApplDataParamName5 = TC_DPCS5
ApplDataParamName6 = TC_DPCS6
ApplDataParamName7 = TC_DPCS7
ApplDataParamName8 = TC_DPCS8
ApplDataParamName9 = TC_DPCS9
ApplDataParamName10 = TC_DPCS10
ApplDataParamIO1 = <EndOfList>
; ApplDataParamIO1 = Type:=Float, Res:=2
; ApplDataParamIO2 = Type:=Int
ApplDataParamSize = TC_DPCS_UNIT
ApplDataParamSize1 = <EndOfList>
; ApplDataParamSize1=TC_DPCS1_UNIT
; ...
; ApplDataParamSize10=TC_DPCS10_UNIT
[ToolEdgeParamsTrafoTextReplace]
; Transformed length 1
TC_DP3 = TTC_DP3
; Transformed length 2
TC_DP4 = TTC_DP4
; Transformed length 3
TC_DP5 = TTC_DP5