Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
208 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
; Transformed radius l1
TC_DP8 = TTC_DP8
; Transformed radius l2
TC_DP9 = TTC_DP9
; Transformed radius r1
TC_DP6 = TTC_DP6
; Transformed radius r2
TC_DP7 = TTC_DP7
; Transformed angle1
TC_DP10 = TTC_DP10
; Transformed angle2
TC_DP11 = TTC_DP11
[CuttEdgeSupervisionOEM]
; [CuttEdgeSupervisionOEM] cutting edge monitoring OEM data
; and application data
; [MagazineOEM] magazine OEM data and application data
; [MagazineLocOEM] magazine location OEM data and application data
; Help for the lines "UserDataParamIO":
; Data format for the data display in magazine list and
; tool list. ; This format is only used for the display and
; in a number of instances as well for entering data.
; "Name parameters" are used in parameter lines.
; The names are separated from the parameter value by ": = ".
; The parameters themselves are separated one each other by ",";
; blanks are permitted to the left and to the right of parameter
names, ":=",
; parameter value and ",".
; Example for the syntax of lines in the OEM data format:
; "[CuttEdgeSupervisionOEM]"
; "UserDataParamIO5=Min:=-9999, Max:=9999 ;comment"
; "5": Number of the OEM data
; "Min:=-9999": For the input: Minimum value
; "Max:=-9999": For the input: Maximum value:
; ";comment": Comment
; Lines UserDataParamName: Locale-specific mechanism
; Lines UserDataParamSize: Locale-specific mechanism
; Lines UserDataParamSizex: Locale-specific mechanism
[CuttEdgeSupervisionOEM]
UserDataParamName1 = TC_MOPC1
UserDataParamName2 = TC_MOPC2
UserDataParamName3 = TC_MOPC3
UserDataParamName4 = TC_MOPC4
UserDataParamName5 = TC_MOPC5
UserDataParamName6 = TC_MOPC6
UserDataParamName7 = TC_MOPC7
To Next Page
Loading...
Need help?
General
