Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
217
16= TC_DP3, 11, TC_DP3
17= TC_DP4, 11, TC_DP4
18= <Empty>
19= <Empty>
20= TC_ADPT1, 11, TC_ADAPT1
21= TC_ADPT2, 11, TC_ADAPT2
22= TC_ADPT3, 11, TC_ADAPT3
23= TC_ADPT4, 4, TC_ADAPT4
24= <EndOfList>
[3_ActList]
NrOfFixedColumns=3
NumLinesPerReq = 11
1= NO, 4, NO
2= MagNo, 4, MagNo
3= ToolInPlace, 3, ToolInPlace
4= TC_TP2, 11, TC_TP2
5= TC_TP1, 5, TC_TP1
6= TC_DPCE, 6, TC_DPCE
7= TC_TP3, 1, TC_TP3
8= TC_TP4, 1, TC_TP4
9= TC_TP5, 1, TC_TP5
10= TC_TP6, 1, TC_TP6
11= TC_TP9, 1, TC_TP9
12= TC_MOP1, 7, TC_MOP1
13= TC_MOP2, 7, TC_MOP2
14= TC_MOP3, 7, TC_MOP3
15= TC_MOP4, 7, TC_MOP4
16= TC_MOP5, 7, TC_MOP5
17= TC_MOP6, 7, TC_MOP6
18= TC_MOP11, 7, TC_MOP11
19= TC_MOP13, 7, TC_MOP13
20= TC_MOP15, 7, TC_MOP15
21= <EndOfList>
[ListColumnHeaderTrafoTextReplace]
; Example:
; TC_DP3 = TTC_DP3
; In the transformed display of lists, this determines the
substitute text
; for the cutting parameters and additive offset parameters
; in the column headers.
; The substitute code for the transformed presentation is searched
for
; in the code "TC_DP3".
; If an entry is missing in this section, then in the
; column header for the corresponding column the
To Next Page
Loading...
Need help?
General
