Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
220 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
TC_ECP34 = TTC_ECP34
TC_ECP35 = TTC_ECP35
e1TC_ECP13 = Te1TC_ECP13
e1TC_ECP14 = Te1TC_ECP14
e1TC_ECP15 = Te1TC_ECP15
e1TC_ECP23 = Te1TC_ECP23
e1TC_ECP24 = Te1TC_ECP24
e1TC_ECP25 = Te1TC_ECP25
e1TC_ECP33 = Te1TC_ECP33
e1TC_ECP34 = Te1TC_ECP34
e1TC_ECP35 = Te1TC_ECP35
e2TC_ECP13 = Te2TC_ECP13
e2TC_ECP14 = Te2TC_ECP14
e2TC_ECP15 = Te2TC_ECP15
e2TC_ECP23 = Te2TC_ECP23
e2TC_ECP24 = Te2TC_ECP24
e2TC_ECP25 = Te2TC_ECP25
e2TC_ECP33 = Te2TC_ECP33
e2TC_ECP34 = Te2TC_ECP34
e2TC_ECP35 = Te2TC_ECP35
e3TC_ECP13 = Te3TC_ECP13
e3TC_ECP14 = Te3TC_ECP14
e3TC_ECP15 = Te3TC_ECP15
e3TC_ECP23 = Te3TC_ECP23
e3TC_ECP24 = Te3TC_ECP24
e3TC_ECP25 = Te3TC_ECP25
e3TC_ECP33 = Te3TC_ECP33
e3TC_ECP34 = Te3TC_ECP34
e3TC_ECP35 = Te3TC_ECP35
[BatchTools]
; Control of the job functions for the tools:
; load, unload or reactivate a number of tools
; Note: The tool filters only work if
; bit 4 (from 0 to ...) is set in the ToolManagementMask.
; Max. 6 filters can be specified.
; The following can be specified for each filter:
; Softkey text, list header, search criteria, selection of the
; type of results list and additional data.
; The ...user\paramini.out file contains error messages for
; errors found on reading the parameters.
; Search criteria:
; Permissible values in "FindCondition":
; A maximum of 8 entries are permissible, separated by ",".
; They are ANDed. In the part conditions
; no data may occur more than once. Each part condition consists
; of three parts:
To Next Page
Loading...
Need help?
General
