Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
221
; 1. Date for which the condition applies
; 2. Condition
; 3. Comparison value
; The following data can be a filter criterion:
; Tool data:
TC-TP1 Duplo number
TC-TP2 Tool identifier
TC-TP3 Tool size in half locations left
TC-TP4 Tool size in half locations right
TC-TP5 Tool size in half locations top
TC-TP6 Tool size in half locations bottom
TC-TP7 Tool location type
TC-TP8 Tool status
TC-TP9 Monitoring type
TC-TP10 Replacement tool search
TC-TP11 Tool information/replacement tool sequence
A_TOOLMN Magazine number
A_TOOLMLN Magazine location number
P_TOOLND Number of cutting edges
; Tool OEM data: "TC_TPC1" to "TC_TPC10"
; The tool OEM data must be activated on the NC
; and the numbers permissible.
; Tool cutting edge parameters:
"TC_DP1" to "TC_DP25", "TC_DPH", "TC_DPV", "TC_DPV3", "TC_DPV4",
"TC_DPV5" (the NCK setting applies instead of "25")
; Tool cutting edge OEM data: "TC_DPC1" to "TC_DP10"
; The tool cutting edge OEM data must be activated on the NC
; and the numbers must be permissible on the NC.
; Tool cutting edge monitoring parameters:
TC_MOP1 Prewarning limit for tool life
TC_MOP2 Actual value for tool life
TC_MOP3 Prewarning limit for workpiece count
TC_MOP4 Actual value for workpiece count
TC_MOP5 Prewarning limit for wear
TC_MOP6 Remaining wear
TC_MOP11 Setpoint for tool life
TC_MOP13 Setpoint for tool workpiece count
TC_MOP15 Setpoint for wear
; Tool cutting edge monitoring OEM data "TC_MOPC1" to
; "TC_MOPC10" tool cutting edge monitoring OEM data must be
; activated on the NC and the numbers must be permissible
; on the NCK. If the NCK version >= 430000: User data
; Tool user data:
; "TC_TPCS1" to "TC_TPCS10"
; Tool user data must be activated on the NC and
; the numbers must be permissible on the NC.
; Tool cutting edge user data:
To Next Page
Loading...
Need help?
General
