Siemens SINUMERIK Commissioning Manual

Tool management
6.2 Settings in the configuration file
HMI Advanced (IM4)
232 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Settings in the INI files
paramtm.ini / paramtm.txt:
[GeneralSettingsForMagAndToolList]
MagPlaceState_Lang_12345678=<Empty> ; use language-DLL
MagPlaceState_Lang_12345678=12345678_MagPlaceState_Lang
; use patm_*.ini
; The new magazine location status bits can be displayed in each
; list display. The parameters are set in the sections:
"[1_MagList]", "[2_MagList]", "[3_MagList]"
"[1_ToolList]", "[2_ToolList]", "[3_ToolList]"
"[1_ActList]", "[2_ActList]", "[3_ActList]"
; Entries are for example:
12=TC_MPP4_9, 1, TC_MPP4_9 ;PlaceStatus Left,
;Reserved in left half location
13=TC_MPP4_10, 1, TC_MPP4_10 ;PlaceStatus Right,
;Reserved in right half location
14=TC_MPP4_11, 1, TC_MPP4_11 ;PlaceStatus Top,
;Reserved in upper half location
15=TC_MPP4_12, 1, TC_MPP4_12 ;PlaceStatus Bottom,
;Reserved in lower half location
16=TC_MPP4_13, 1, TC_MPP4_13 ;PlaceStatus Bit 13 of 1 to 16
17=TC_MPP4_14, 1, TC_MPP4_14 ;PlaceStatus Bit 14 of 1 to 16
18=TC_MPP4_15, 1, TC_MPP4_15 ;PlaceStatus Bit 15 of 1 to 16
19=TC_MPP4_16, 1, TC_MPP4_16 ;PlaceStatus Bit 16 of 1 to 16
patm_gr.ini:
[GeneralSettingsForMagAndToolList]
12345678_MagPlaceState_Lang="123456789ABCDEFG" ; // 16 exact
[ListColumnHeaderText]
TC_MPP4_9 = "P" ;PlaceStatus Left,
;Reserved in the left half loc. // 1
TC_MPP4_10 = "P" ;PlaceStatus Right,
;Reserved in the right half loc. // 1
TC_MPP4_11 = "P" ;PlaceStatus Top,
;Reserved in the top half loc. // 1
TC_MPP4_12 = "P" ;PlaceStatus Bottom,
;Reserved in the bottom half loc. // 1
TC_MPP4_13 = "P";PlaceStatus undefined,
;(Wear group disabled) // 1
TC_MPP4_14 = "P" ;PlaceStatus Bit14 of 1 to 16 // 1
TC_MPP4_15 = "P" ;PlaceStatus Bit15 of 1 to 16 // 1
TC_MPP4_16 = "P" ;PlaceStatus Bit16 of 1 to 16 // 1

Siemens SINUMERIK Specifications

General

Brand	Siemens
Model	SINUMERIK
Category	Control Unit
Language	English