List of the INI Files
A.9 HEADER.INI
HMI Advanced (IM4)
284 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
33=CondWait.bmp ; Axis exchange active
; block change inhibited because axis exchange in progress
34=CondWait.bmp ; Axis container rotation
35=CondWait.bmp ; AXCT: Following axis active
36=CondWait.bmp ; AXCT: Leading axis active
37=CondWait.bmp ; AXCT: Follow up mode active
38=CondWait.bmp ; AXCT: Internal status change
39=CondWait.bmp ; AXCT: Axis/spindle inhibit
40=CondWait.bmp ; AXCT: Corr. motion active
; Axis container exchange: Overlaid movement
41=CondWait.bmp ; AXCT: Axis exchange active
42=CondWait.bmp ; AXCT: Axis interpolator active
43=CondWait.bmp ; Waiting for compile cycle
44=CondWait.bmp ; Access to system variable
45=CondStop.bmp ; Search target found
; (block search has found search target and the NCK has
stopped)
46=CondWait.bmp ; Rapid retraction started
47=CondWait.bmp ; AXCT: Waiting for spindle stop
; Axis container exchange
48=CondWait.bmp ; Machine data alignment (;New-Config)
49=CondWait.bmp ; Axis exchange: Axis in coupling
50=CondWait.bmp ; Axis exchange: Liftfast active
51=CondWait.bmp ; Axis exchange: New-Config active
52=CondWait.bmp ; Axis exchange: AXCTSW active
53=CondWait.bmp ; Axis exchange: WAITP active
54=CondWait.bmp ; Axis in another channel
55=CondWait.bmp ; Axis exchange: Axis PLC axis
56=CondWait.bmp ; Axis exchange: Axis oscillating axis
57=CondWait.bmp ; Axis exchange: Axis JOG axis
58=CondWait.bmp ; Axis exchange: Command axis
59=CondWait.bmp ; Axis exchange: Axis OEM axis
60=CondWait.bmp ; Coupled following axis
61=CondWait.bmp ; Coupled-motion following axis
62=CondWait.bmp ; Coupled slave axis
63=CondWait.bmp ; Stop at cycle end M0
64=CondWait.bmp ; Stop at cycle end M1
65=CondWait.bmp ; Wait: Axis is at endstop
66=CondWait.bmp ; "Master-slave switchover active"
67=CondWait.bmp ;"Axis exchange: Axis single axis"
68=CondWait.bmp ; "Stop: Target reached after block search"
To Next Page
Loading...
Need help?
General
