EasyManuals Logo
Home>Siemens>Control Unit>SINUMERIK

Siemens SINUMERIK Commissioning Manual

Siemens SINUMERIK
736 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #605 background imageLoading...
Page #605 background image
Introduction
1.4 Tools
Generating target language texts (TX2)
Commissioning Manual, 11/2006, 6FC5397-0DP10-0BA0
7
Operating system and target language from the same language family
If the language of the operating system (e.g., German) belongs to the same language family
as the target language (e.g., Portuguese), then some difficulties could possibly occur with
the input of certain characters. However, there will be no problems displaying these
characters with a simple text editor.
Remedy:
Use the Windows "Character Map" tool
(see Section "Input via the Character Map") or
or switch the keyboard
(see Section "Using a different keyboard assignment") or
use the ALT+digit combination to enter these characterseinzelne Zeichen mit
ALT+Ziffernkombination eingeben
(see Section "Numerical text input")
There should not be any further problems in this case. Use a simple text editor (e.g.,
Notepad) and save the texts in the usual way.
Section "Files with Word 2003" does not apply.
Operating system and target language from different language families
If the language of the operating system (e.g., German) does not belong to the same
language family as the target language (e.g., Hungarian), difficulties will occur with both
inputting and displaying the characters in a simple text editor (Notepad).
1.4 Tools
Standard version
This document describes the use of Microsoft Word 2003 and other tools which may not
necessarily be installed on your PC.
You should have installed the following components:
Microsoft Word 2003 (required)
Windows XP: Language Support for East Asian characters (necessary for these
languages)
Windows XP: Character Map (recommended)
Checking the installation of the Language Support for East Asian languages
To install the Language Support for East Asian languages, please refer to Section "Special
considerations when working with East Asian languages".

Table of Contents

Other manuals for Siemens SINUMERIK

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Siemens SINUMERIK and is the answer not in the manual?

Siemens SINUMERIK Specifications

General IconGeneral
BrandSiemens
ModelSINUMERIK
CategoryControl Unit
LanguageEnglish

Related product manuals