Configuring the HMI system
2.2 Configuring a channel menu
HMI Advanced (IM4)
60 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
Differences between HMI sl and HMI Advanced
For HMI Advanced, a channel menu for the direct channel selection must be configured in
addition to the channel groups that are used for switching over the operating stations. This
configuration is not evaluated or might be missing for HMI sl.
The HMI Advanced then responds as follows:
● If the PCU 50.3 has a local display and if this local display has the operating rights,
channels are selected directly via the channel menu.
● If an operating station with TCU for which no channel menu is configured in its file
CONFIG.INI has the operating rights on PCU 50.3, channels are selected directly via the
channel menu.
● If an operating station with TCU for which one channel menu is configured in its file
CONFIG.INI has the operating rights on PCU 50.3, operating station switchover is
performed via the channel menu as defined in the configuration.
HMI sl responds as follows:
● If an operating station for which no channel menu is configured has the operating rights,
the channel switchover key is local, without a channel menu, i.e. switching to the next NC
channel.
● If an operating station for which one channel menu is configured in its file CONFIG.INI
has the operating rights, operating station switchover is performed via the channel menu
as defined in the configuration.
See also
On displaying the channel menu in HMI Advanced: Configuration of a channel menu for
direct channel selection (1:1 configuration) (Page
53)
Configuration of the channel groups (NETNAMES.INI)
[own]
owner= HMI_1
[chan HMI_1] /* channel menu for direct channel
selection
DEFAULT_logChanSet=channels /* obligatory for HMI Advanced
DEFAULT_logChan=K_1 /* of no significance for HMI sl
ShowChanMenu=True
logChanSetList=channels
[channels]
logChanList=K_1, K_2, K_3, K_4
[K_1]
logNCName=NCU_1
ChanNum=1
To Next Page
Loading...
Need help?
General
