Siemens SINUMERIK

Configuring the HMI system
2.2 Configuring a channel menu
HMI Advanced (IM4)
62 Commissioning Manual, 03/2009, 6FC5397-0DP10-3BA0
[CH_GRP_3]
Text = Transport
Member1.Target = NCU720-1.#1
Member1.Text = NCU720_K1
Member2.Target = NCU720-1.#2
Member2.Text = NCU720_K2
Member3.Target = NCU720-1.#3
Member3.Text = NCU720_K3
Member4.Target = NCU720-1.#4
Member4.Text = NCU720_K4
…
[CH_GRP_15]
Text = Headend
Member1.Target = 192.168.214.241.#1
Member1.Text = NCU720_K1
Member2.Target = 192.168.214.241.#2
Member2.Text = NCU720_K2
Member3.Target = 192.168.214.241.#3
Member3.Text = NCU720_K3
Member4.Target = 192.168.214.241.#4
Member4.Text = NCU720_K4
Configuration for an operating station
The channel menu for an operating station is configured in its file CONFIG.INI in section
[T2M2N]. There the channel groups to be used for the operating station as defined in file
NETNAMES.INI are assigned to the horizontal softkeys of the channel menu for this
operating station.