Operating
6.2 Operating modes
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
109
● Stroke number
● Number of changes in direction
● Number of fault messages
Note
Setting the mode
The "Automatic" and "Manual" modes remai
n set when switching to the "Diagnostics"
The positioner responds as per the configured mode:
The predefined setpoint is used as a control variable in the automatic mode.
The last reached position is retained in the manual mode.
Commissioning (Page 113)
Overview parameters A to P (Page 154)
Overview of diagnostics values (Page 208)
Meaning of the diagnostics values (Page 211)
To Next Page
Loading...
