Siemens SIPART Series - Page 159

Parameterizing/addressing
9.3 Overview of parameters
SIPART PS2 with and without HART
Operating Instructions, 10/2013, A5E00074631-11
157
Overview parameter J
Parameter
Function
Parameter values
Unit
J. TMAX
Monitoring of the upper limit temperature with the following parameters:
J1.TUNIT
Temperature unit
°C
°F
°C/°F
J2.LEVL1
Threshold 1
-40 ... 75 ... 90
-40 ... 194
J3.LEVL2
Threshold 2
-40 ... 80 ... 90
-40 ... 194
J4.LEVL3
Threshold 3
-40 ... 90
-40 ... 194
Overview parameter L
Parameter
Function
Parameter values
Unit
L. STRK
Monitoring the path integral with the following parameters:
L1. LIMIT
Limit for the number of changes of direction
1 ... 1E6 ... 1E8
L2.FACT1
Factor 1
0.1 ... 1.0 ... 40.0
L3.FACT2
Factor 2
0.1 ... 2.0 ... 40.0
L4.FACT3
Factor 3
0.1 ... 5.0 ... 40.0
Overview parameter O
Parameter
Function
Parameter values
Unit
O. DCHG
Monitoring the changes in direction with the following parameters:
O1.LIMIT
Limit for the number of changes of direction
1 ... 1E6 ... 1E8
O2.FACT1
Factor 1
0.1 ... 1.0 ... 40.0
O3.FACT2
Factor 2
0.1 ... 2.0 ... 40.0
O4.FACT3
Factor 3
0.1 ... 5.0 ... 40.0
Overview parameter P
Parameter
Function
Parameter values
Unit
P. PAVG
Position mean value calculation with the following parameters:
P1.TBASE Time base of the mean value generation
0.5h
/ 8h / 5d / 60d / 2.5y
P2.STATE
State of the position mean value calculation
IdLE / rEF / ###.# / Strt
P3.LEVL1 Threshold 1 0.1 ...
2.0
... 100.0 %
P4.LEVL2
Threshold 2
0.1 ... 5.0 ... 100.0
%
P5.LEVL3
Threshold 3
0.1 ... 10.0 ... 100.0
%