Siemens SIPART Series - Page 44

Installing/mounting
4.3 Mounting the part-turn actuator
SIPART PS2 with and without HART
42 Operating Instructions, 10/2013, A5E00074631-11
Figure 4-6 Carrier
4. With the coupling wheel: Place the positioner and the mount on the actuator carefully.
The pin of the coupling wheel
① must fit in the carrier ② when you do this.
With the stainless steel coupling: Place the positioner and the mount on the actuator
carefully. Place the stainless steel coupling on the stump of the actuator's positioner
shaft.
Actuator, non-flameproof enclosure
Actuator, flameproof enclosure
5. Align the positioner/mount unit at the center of the actuator.
6. Tighten the positioner/mount unit.
7. Initialize the positioner.
8. After commissioning, drive the positioner to the end position.