Y070.302/EN Page 105
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
12
Diagnosis
12 Diagnosis
Switching cycles per hour
Average number of switching cycles/hour calcu-
lated over the last 10 minutes.
Torque cut-offs
Total number of torque-dependent cut-offs since
commissioning.
Travel cut-offs
Total number of travel-dependent cut-offs since
commissioning.
Motor operating hours
Total number of motor operating hours since
commissioning.
Electronic operating hours
Total number of electronics unit operating hours
since commissioning.
Cycles per hour
Relative operational time during the last 10
minutes.
For further information on actuator maintenance,
refer to chapter „14 Maintenance, inspection,
service“ on page 111.
The Diagnosis menu has three submenus:
■
Operation data actuator
■
Valve maintenance limits
■
Maintenance valve
The illustration on the right shows the functions.
12�1 Operation data actuator
Information on the actuator is displayed here.
Switching cycles
Totalnumberofswitchingcyclessincerstcom-
missioning.
Fig�: ‘Diagnosis’ menu
not necessary
necessary
Maintenance reset
Diagnosis
Switching cycles XX
Switching cycles per hour X
Motor operating hours
Switching cycles XXXXXXXX
Torque cut-offs X
Electronic operating hours XXX
Torque cut-offs XXXX
Travel cut-offs X
Cycles per hour [%] X
Motor operating hours XXX
Operation data actuator
Valve maintenance limits
Maintenance valve
Main menu
Alternative control mode
12 Diagnosis (operating data and maintenance
limits)
Operational data is collected and stored in the RAM. For backup purposes, the data is written to
theinternalEEPROM.Thevaluesformaintenancelimitsarestoredforanymodication.Therefore
operational data and the values for the maintenance limits are safe, even in case of power failure.
Operating data and maintenance limits can be read via the “Diagnosis” menu. The indicated values
cannot be changed as they represent the state of the actuator.
Fig�: ‘Diagnosis’ menu function
To Next Page
Loading...