Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 8 Y070.302/EN
2 General information
2
General information
2�2 Sub-assemblies
The actuators of the SIPOS SEVEN series
comprise two main assemblies: gear unit and
electronics unit.
For details, refer to chapter „15.3 Exploded
views“.
The main sub-assembly gear consists of
the sub-assemblies:
1 Plug element electronic connection,
2 Motor,
3 Gear unit,
4 Signaling gear or non-intrusive position en-
coder (not for 2SG7) with cover,
5 Manual drive (with crank or hand wheel),
6 Possible mechanical extensions, depending
on the version.
For the 2SG7 and 2SQ7 small part-turn actua-
tors, the signaling gear is omitted and the gear
unit has a different shape. For 2SG7, the manual
drive has a different design.
The main sub-assembly electronics unit
consists of the sub-assemblies:
1 Electrical connection (two versions available),
2 Plug element gear connection,
3 Electronic housing with cover,
4 Power control PCB, including power module,
Fig�: Gear unit sub-assemblies
Fig�: Electronics unit sub-assemblies
5 Relay board (option),
6 Control PCB with display
7 Additional analog module for additional input
and output (option) or HART control input
(option).
To Next Page
Loading...
