SIPOS SEVEN 2SA7 - Communication and Data Exchange; Remote Control; COM-SIPOS PC Parameterization Software

Y070.302/EN Page 107
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
13
Communication and data exchange
13 Communication and data exchange
13 Communication and data exchange
In addition to operation directly at the actuator, the actuator can also be controlled
■
from remote (DCS, automation system);
■
via the COM-SIPOS PC parameterization system whereby data exchange via Bluetooth or USB
cable is possible.
13�1 Remote control
Depending on the automation system and the parameterization for "REMOTE control" and "Alterna-
tive control mode" (refer to chapter 8), actuator control is done via
■
Conventional connection (24/48 V binary or 0/4 – 20 mA analog) or
■
Fieldbus (e.g. PROFIBUS DP, MODBUS or HART).
Theoperationviaaeldbusinterfaceisalsodescribedinseparateoperationinstructions,referalso
to chapter 1.5 "Supplementary operation instructions".
An EMERGENCY command sent from the DCS is always executed by the actuator (irrespective
of the selected control type and signal source), even if the actuator is conventionally controlled
andtheEMERGENCYcommandissentviaeldbusandviceversa.
13�2 COM-SIPOS PC parameterization software
The COM-SIPOS PC parameterization program is a software tool for:
■
Operation: Operation of the actuator in LOCAL mode
■
Observe: Reading the actuator parameters and the device state;
■
Diagnosis: Trouble shooting;
■
Parameterization: Reading and changing the actuator parameters;
■
Loadingnewrmware:Softwareupdatetothestate-of-the-art;
■
Archiving: Saving of the actuator parameters and torque reference curves of the actuator.
Connection from the laptop to the actuator is possible via:
■
Bluetooth
The communication is wireless via the Bluetooth interface integrated in the actuator.
■
USB cable
Communication is established via the USB port on the left bottom of the electronics housing.
Refer also to the following chapter.
The COM-SIPOS PC parameterization program is described in separate operation instructions.