SIPOS SEVEN 2SA7 - Clone Actuator

Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 110 Y070.302/EN
13 Communication and data exchange
13
Communication and data exchange
13�4�5 Clone actuator
Only available in ‘Expert’ user level and in ‘LOCAL’ or ‘Off’ mode.
The ‘Clone actuator’ function is used to write all actuator parameter values (factory parameters
includingendpositionadjustment,parameterswhichcanbemodiedbythecustomerand
operating data such as motor operating hours, number of cut-offs, etc.), which were written to
theUSBashdrive(referto„13.4.2DownloadparameterstoUSBashdrive“onpage109),to
a ‘new’ electronics unit. In terms of the functions, the actuator with the ‘new’ electronics unit is a
duplicate of the ‘original actuator’.
This function enables quick and easy commissioning, for example after replacing the electronics
unit.
Fig� 1: Clone actuator procedure
Operation sequence
1. ConnectUSBashdrivetotheoriginalelec-
tronicsunitrefertog.,item1.
The‘USBashdrive’menuappears.
2. Select “Download parameters” from the
menu (item 2)andconrm.(referalsoto
„13.4.2DownloadparameterstoUSBash
drive“ on page 109.
The.STEleissavedtotheUSBashdrive.
Successfulsavingisconrmedviaames-
sage.
3. ConnectUSBashdrivetothe‘”new”re-
placementelectronicsunit(g.,item3). The
‘USBashdrive’menuappears.
4. Select“Cloneactuator”inthemenu(g.,
item 4)andconrm(2).Thedisplaychanges
tothe“Selectle”menu.
5. Select.STEleofthe‘originalactuator’and
conrm.
A note is displayed requesting you to verify
whether conversion rate and mains voltage
of the target actuator match.
6. If not, abort cloning selecting “No”. If yes,
continue cloning selecting “Yes”.
DataiswrittenfromtheUSBashdriveto
theactuator.Successfulcloningisconrmed
withamessage,refertog.3.
Fig� 2: Note: Check conversion rate and
mains voltage
Fig� 3: Message: Cloning successful