SIPOS SEVEN 2SA7 - Control System Parameters; Overview of Control System Menu

Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 66 Y070.302/EN
8 Parameters and possible parameter values
8.3 Parameters for the DCS
8
Parameters and possible parameter values
8�3 Control system parameters
8�3�1 Overview of Control system menu
The orange selection marker cannot be set to the blue group header, but directly on the lines
below showing the possible parameter values.
Thefollowingoverviewlistspossibleparameters.Dependingontheproductconguration,the
indication in the display may vary.
Parity/stop bit
Monitoring time
Baud rate
Monitoring time 0 – 3600 s.
Main menu
Parameter
Control system
Control mode
Alternative control mode
Binary input
MODE input
Binary
Binary
Normally Open (NO)
Interlock LOCAL/REMOTE
Enable motor operation
Enable LOCAL
Not active
Normally Closed (NC)
No function
Pulse contact
Slope
Slope
Proportional move
Proportional move
Rising
Rising
Analog
Analog
Falling
Falling
Fieldbus
Fieldbus
Signal assignment
Internal
Internal
Channel 2
Process actual value
Range
Positioner AI1
Positioner AI1
Range
Permanent contact
Permanent contact
Output 1
Signal
Level
Output 2
Output 3 ... 8
Processcontrollerxedsetpoint
Processcontrollerxedsetpoint
Process controller AI1
Process controller AI1
4 – 20 mA
Process data
4 – 20 mA
Positioner
Positioner
Analog output AO1
Analog output AO2
Fieldbus
Process controller AI2
Process controller AI2
0 – 20 mA
0 – 20 mA
Process controller
Process controller
PROFIBUS DP
MODBUS
HART
Signal
For available additional analog module only.
Parameterization like for analog output AO1.
Process controller AI2
Process controller AI2
Binary outputs
Proportional move
Proportional move
Channel 1
Address
Address 0 – 63
Position actual value
Permanent contact
Permanent contact
Analog input AI1
Slope
Rising
Falling
Range
4 – 20 mA
0 – 20 mA
Analog input AI2