SIPOS SEVEN 2SA7 - Fast to Local; Set Standby Time; Activate Standby; Adjust Real Time Clock

Y070.302/EN Page 95
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
9
System settings
9 System settings
Operation sequence
1. Select 'System settings’ in the main menu
(g.,item1)andconrm(item2).
‘The ‘System settings’ menu appears.
2. Set selection marker to ‘Real time clock‘ (3)
andconrm(4).
The ‘Real time clock’ menu appears and
both date and set time is displayed.
3. Set selection marker to date or time (5) and
conrm(6).
The display changes to the setting menu, in
our example, of the date. The current setting
is displayed.
4. Set selection marker to the number to be
changed (7) (the frame around the number
changes from blue to orange) and con-
rm(8).
5. Change number (turn Drive Controller) (9)
andconrm(pressDriveController)(10).
The orange selection marker changes to
‘Save’.
6. Conrmsaving(11)
Display changes to 'Real time clock' menu
and the changed value is displayed'.
Fig�: Adjust real time clock
9�1�3 Fast to local
This setting is reasonable under critical conditions where immediate operation is required directly at
the actuator, irrespective of control and user level.
If the Drive Controller is held down in standby mode during “Fast to local”, the actuator switches to
■
Local operation: The operation direction can be immediately selected and the actuator be oper-
ated, even if ‘Observer’ user level is set;
■
Control from “REMOTE” to “LOCAL”,
■
The user level to the highest access level with password ‘0000’, if password “0000” has been
assigned to the lower user levels. Refer to hints in chapter „6.4 Enable user level“ on page 33.
For set “Fast to local” function, the display shows the same standby screen as for
‘Position+Bar+Status’ selection, refer to above.
9�1�4 Set standby time
Thestandbytimedenestheinterval,afterhowmanyminutesafterthelastoperationoftheDrive
Controller the display will change to standby mode.
Default setting is 10 minutes.
9�1�5 Activate Standby
Via this menu item, the display is directly switched to the standby mode;
■
The brightness of the display is dimmed;
■
The selected standby screen appears and
■
The user level is reset according to the settings, refer to chapter „6 User management“ on page
31.
9�2 Adjust real time clock
On delivery, date and time match the time zone of the manufacturer.