SIPOS SEVEN 2SA7 - Optional Software Functions

Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 82 Y070.302/EN
8 Parameters and possible parameter values
8.5 Software functions
8
Parameters and possible parameter values
8�5�4 Optional software functions
■
Positioner (for the description refer to „8.5.2 Positioner“ on page 80), order no.: 2SX7200-
3FC00*
Type: 2S � 7 � � � - � � � � � -4 � B .
For HiMod, the "positioner" software function is included in the scope of delivery.
■
Process controller (PI controller), order no.: 2SX7200-3FG00* or 2SX7200-3FG08 for HiMod.
Type: 2S � 75 � � - � � � � � -4 � C/L . or 2SA78 � � - � � � � � -4�C/L.
Supplementary operation instructions Y070.346
■
Travel-dependent speed adjustment (speed curve)**, order no.: 2SX7200-3FD00*
Type: 2S � 7 � � � - � � � � � -4 � D/E .
Supplementary operation instructions Y070.345
■
External analog speed setpoint**, order no.: 2SX7200-3FE00*
Type: 2S � 7 � � � - � � � � � -4 � F/G .
Supplementary operation instructions Y070.344
■
Positioner with split range function, order no.: 2SX7200-3FG00* or 2SX7200-3FG08 for HiMod.
Type: 2S � 7� � � - � � � � � -4 � H �
Supplementary operation instructions Y070.343
■
Travel-dependent freely settable positioning times, order no.: 2SX7200-3FJ00*
Type: 2S � 7 � � � - � � � � � -4 � J/K.
Supplementary operation instructions Y070.340
Order number for subsequent enabling of the software function.
** - Speed for 2SA7 rotary actuator� � � ;
- Positioning time for 2SG7, 2SQ7 part-turn actuator. . . or 2SA7. . . with part-turn gearbox
Always state the serial number of the actuator
when ordering the optional software functions at
a later date.
Serial number is indicated on the name plate of
theelectronicsunit(refertog.)andcanalsobe
viewedvia‘Mainmenu’►'Observer'►Elec-
tronicnameplate►Serialnumber.
If the control board was exchanged, the serial
number of the new control board is not identical
to the number on the name plate. When ordering
the software function, always state the number
displayed in the "Observe" menu.
Enabling an optional software function is
described in the previous chapter. If a later
rmwareversionisrequiredforasoftwarefunc-
tion,thermwarecanberequestedfromthe
Service..
Thermwareupdateoftheactuatorisper-
formed with the COM-SIPOS parameterization
software.
Duringarmwareupdate,theactuatorparam-
eters (customer settings and work parameters)
including end position setting and operational
data are not changed.
Fig�: Serial number on electronics unit