SIPOS SEVEN 2SA7 - Special Parameters; Fig.: ‘Special Parameters’ Menu

Y070.302/EN Page 83
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
8
Parameters and possible parameter values
8 Parameters and possible parameter values
8�6 Special parameters
Special parameters enable adaptation of the actuator behavior to the automation environment.
Furthermore,theyallowefcientplanningofvalvemaintenanceintervalsinrelationtothenumber
of starts or the operating hours.
The following illustration shows an overview of the “Special parameters” menu.
Fig�: ‘Special parameters’ menu
Special parameters
Tag number entry
Noneor<=10m
X %
Motor heating On/Off
Switching cycles (in thousands)
On/Off
On/Off
0.1 to 1.0/2.0 s
Not valid
0 to 250 %
Normal
Pause CLOSE XXXX s
Lower threshold X,X mA
Test operation On/Off
0.1 to 25.0 s
0.0 to 25.5 s
On/Off
On/Off
On/Off
Motor warning [°C]
Torque cut-offs XXXXX
Analog input AI1
Quick start
Runtime OPEN XXXX s
Upper threshold XX,X mA
Runtime CLOSE XXXX s
>10mwithlter
XX %
Motor protection On/Off
Motor operating hours XXXX
Analog input AI2
Quick start/stop
Pause CLOSE XXXX s
Tag number
Separate mounting
Intermediate contact
Motor
Valve maintenance intervals
Close tightly*
Check maintenance*
Rise time*
Torque measurement ange*
DC brake*
End position speed
Threshold open circuit analog input*
Test operation*
Delay of Power failure message*
DCS acceptance time*
DC link voltage limitation*
Runtime monitoring*
Autom� TL adapt� end position*
Parameter
* These parameters can only be
changed in the ‘Expert’ user level
(refer also to „6 User management“ on
page 31).
8�6 Special parameters