SIPOS SEVEN 2SA7 - Assign Password to User Level;Change Password of a User Level

Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
Page 32 Y070.302/EN
6 User management
6
User management
3. Once work is complete
Reset user access level:
‘Usermanagement'-->Set'Observer'.
‘Observer' is the user level (default setting) the actuator changes to when not operated for more
than 10 minutes. Exception if "0000" was assigned as password, refer to the following note
on Page 33.
6�3 Assign password to user level/change password of a user
level
The password can only be changed for the current user or a lower user level.
1. Select 'User management' in the main menu.
The 'User management' menu with the menu
items
– Current user,
– Administration opens.
2. Set orange selection marker to 'Change
password'menuitem(g.2,item1).
3. Conrmselection(g.2,item2).
The display changes to 'Change password'
menu.
4. Select user level, set orange selection
marker to the desired user level (item 3).
5. Conrmselection(4).
Display changes to the entry of the new
password. The currently assigned password
isdisplayedandtheframeoftherstdigitis
shaded in orange.
6. Iftherstdigitis
a) not to be changed:
Turn Drive Controller, the frame of the
next digit changes to orange.
or
b) to be changed:
- PressDriveController(digitisashing).
- Turn Drive Controller (5), until the
desired digit of the new password is
displayed.
- Conrmselection(6). The changed digit
is accepted and
thenextdigitisashing.
7. Repeat step 6 until all four digits have been
entered. Once the fourth digit has been con-
rmed(item7), the selection marker jumps
to menu item 'Continue’.
8. Press Drive Controller (item 8).
Display changes to the 'User management'
menu.
User management
Observer (= log out)
Supervisor
Current user
Administration
Operator
Expert
Change password
Main menu
Alternative control mode
Fig� 1: User management menu
Fig� 2: Assign user access level