SIPOS SEVEN 2SA7 - Parameters and Possible Parameter Values; Parameter Menu

Y070.302/EN Page 61
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
8
Parameters and possible parameter values
8 Parameters and possible parameter values
8�1 Parameter menu
8 Parameters and possible parameter values
The present chapter describes the parameters and the possible parameter values.
The following overview shows the parameter menu.
8�1 Parameter menu
Valve
Additional gear
Parameter
Control system
Safety
EMERGENCY speed
EMERGENCY input
Positioning time curve
EMERGENCY position
Control source fault
Tag number
Software functions
Special parameters
Proportional move
Positioner
Intermediate contacts
Motor
Close tightly
Analog input AI1
Alternative control mode
Analog input AI2 (option*)
Analog output AO1
Analog output AO2 (option*)
Fieldbus (if available)
Binary outputs
Binary input
MODE input
Control mode
Enable software functions
Process controller
Separate mounting
Analog speed setpoint
Speed curve
Customer variant
Split range function
Valve maintenance intervals
Check maintenance
Rise time
Torquemeasurementange
Delay of Power failure message
Test operation
Runtime monitoring
Autom. TL adapt. end position
DCS acceptance time
DC brake
Threshold open circuit analog input
DC link voltage limitation
End position speed
End position range
Retry torque block
Tripping torque
Factor output/input torque
1
Signaling gear setting
2
Reduction ratio
1
Rev./stroke
1,2
Cut-off mode
CLOSE direction
Speed
Types of gearings
Max. output torque
1
Model
Max. input speed
Page 66
Page 62
Page 36
Page 77
Page 78
Page 83
A
A
*
1
Data varies depending on the gear
type.
*
2
Actuators with signaling gear only
**
*
*
* Not for 2SG7, 2SQ7
** Not for 2SQ7