SIPOS SEVEN 2SA7 - Enable User Level

Y070.302/EN Page 33
Operation instructions
SIPOS SEVEN: PROFITRON, HiMod
6
User management
6 User management
6�4 Enable user level
1. Select 'User management' in the main menu.
The 'User management' menu with the menu
items
– Current user,
– Administration opens.
2. Set the orange selection marker to the line
below"Currentuser"(g.,item1).
3. Conrmselection(g.,item2)
Display changes to 'Current user' menu.
Remark: The current user level is ticked
.
4. Select desired user level; set orange selec-
tion marker to the desired 'User level', in our
example 'Supervisor' (item 3).
For information on 'Observer' user level,
refer to note below.
5. Conrmselection(item4).
Display changes to prompt of the 4-digit
password,theframeoftherstdigitis
shaded in orange.
6. TurnDriveController,untiltherstdigitof
the password is displayed (item 5).
If the user has not yet entered an individual
password, the default password applies
(refer to table in the previous chapter "4.7.1
General").
7. Conrmselection(item6)
Selection marker prompts the entry of the
second digit.
8. Repeat operation steps 6 and 7 (item 5 and
6) until all four digits have been entered.
Oncethefourthdigithasbeenconrmed
(item 7), the selection marker jumps to
'Continue’.
9. Press Drive Controller (8).
Display changes to 'User management'
menu and 'Supervisor' is displayed as 'Cur-
rent user'.
■
If a user level is assigned the password "0000", this user level remains enabled, even if the
password “0000” has also been assigned for lower user levels. Renewed enabling is not re-
quired.
■
If the user levels have been assigned individual passwords (not "0000"), the following applies:
– Logging out from a password-protected user level is done by changing to the 'Observer' user
level.
– If not operated for more than 10 minutes, the user level is automatically reset to 'Observer' or
to the highest access level with password ‘0000’.
– Before changing an existing password of a user level, the user level or a higher user level
hastobeenabledrst.
– If you have forgotten the password of a user level, it can be reset with the next higher user
level, 'Administration' menu item.
■
If a function has been selected for which you have no access rights (e.g. parameters written in
gray), a message prompting to change the user level appears.
Fig�: Enable user level