M
ULTICAST
C
ONFIGURATION
2-115
• IGMP Query Count — Sets the maximum number of queries
issued for which there has been no response before the switch
takes action to drop a client from the multicast group. (Default:
2, Range: 2 - 10)
• IGMP Query Interval — Sets the frequency (in seconds) at
which the switch sends IGMP host-query messages. (Default:
125, Range: 60 - 125)
• IGMP Report Delay — Sets the time (in seconds) between
receiving an IGMP Report for an IP multicast address on a port
before the switch sends an IGMP Query out of that port and
removes the entry from its list. (Default: 10, Range: 5 - 30)
• Query Timeout — The time the switch waits after the previous
querier stops before it considers the router port (i.e., the
interface which had been receiving query packets) to have
expired. (Default: 300 seconds, Range: 300 - 500)
• IGMP Version — Sets the protocol version for compatibility
with other devices on the network. (Default: 2, Range: 1 - 2)
Notes: 1. All systems on the subnet must support the same
version.
2. Some attributes are only enabled for IGMPv2, including
IGMP Report Delay and IGMP Query Timeout.
b_mgmt.book Page 115 Tuesday, July 8, 2003 5:24 PM
To Next Page
Loading...
